Stuart Turner
bathroom shower pumps |
Stuart Turner shower pumps are manufactured under a quality system
approved to ISO9002 and conform to all relevant
standards. They are easily installed in bathrooms and maintenance
free, designed to give you years of enhanced
showering pleasure, and carry a full two-year
parts and labour guarantee and supported by
a network of service engineers.
 Stuart Turner Medium
pressure bathroom shower pumps will
turn your dribbling showers into a heady flood,
just right for family bathrooms. With the shower pump
silently boosting the bathrooms water supply
up to a medium pressure, you will find that
you can now fit a choice of heads. This could
include a multi-function spray which offers
you the choice of a relaxing foam, ideal for
washing hair and young children, through to
invigorating needle and massage jets. The choice
is yours.
Shower pumps by Stuart Turner can deliver
water at high pressure giving you the power
normally experienced in the USA or Continental
Europe. A high pressure system allows you to
fit the widest possible choice of bathrooms fittings,
including all round body jets or rain bars,
as well as multi-function head's. It's the ultimate
luxury shower experience ... Live the dream
and shower like you've never before.
 |
4 Bar Twin Impeller |
Stuart Turner have
a range of 6 bathroom shower pumps constructed
in brass and designed to meet the pressure boosting
demands found within most bathrooms in domestic and light commercial
property.
The shower pumps
range from Stuart Turner offers a choice of both Single and Twin
pumps with the either flow switch positive or
pressure / flow switch negative head fully automatic
control systems. All are supplied with anti-vibration
feet, flexible hoses, inlet strainers and power
supply cable and are ready to install, for that
extra piece of mind Stuart Turner shower pumps carry a full two-year
guarantee.
Stuart Turner shower pumps are
driven by a continuously rated thermally protected
induction motor. Designed to boost both the hot
and cold water supplies they can be used to boost
water pressure to bathrooms, whole flats / houses
and commercial premises. In situations where there
is less than 0.5 L per minute flow then the pump
can be started with the addition of an air or
non-latching pull cord switch or alternatively,
for automatic operation, a negative flow pump
can be used.
How to choose Stuart Turner shower
pumps
1. With your plumber estimate the maximum flow
required in litres per minute.
2. Check pressure reqirements of equipment to
be used in metres head.
3. Select the performance curve for the type of
shower pumps required.
4. From the horizontal scale on the chart (see
below) read vertically upwards from the flow rate
in litres per minute desired. Where this line
intersects the performance curve it will show
the pressure of the shower pump in metres head on the
vertical scale. As long as that head of pressure
is sufficient to drive the showers equipment selected,
the minimum size should be used.
5. Remember the pressure is in addition to the
static pressure that may exist within the system. |
